14
15
ASSEMBLY
1. Lift the rear flap with one hand and push the mulching plug into the rear discharge chute until it is
locked in place. Make sure that the mulching plug is locked in position. (See Fig. 9).
Fig. 9
2. Release the rear flap, it will close back to cover the mulching plug.
3. If you want to remove the mulching plug, hold the handle of the mulching plug, press down the hook
with your finger, meanwhile lift it upward slightly and pull it out.
Installing the side discharge chute
NOTE:
Switch off the tool and make sure that the blade has stopped completely. Then remove the
battery completely.
1. The mulching plug should be installed as described above.
2. Lift the side discharge cover with one hand and hook in the side discharge chute with the other hand.
(See Fig. 10)
Fig. 10
3. Release the side discharge cover to secure the chute in position. (See Fig. 11)
Fig. 11
Set required function
WARNING!
Before changing any accessory, switch off the tool and make sure that the blade has
stopped completely. Then remove the battery completely.
NOTE:
his lawn mower has three functions. These functions can be converted by changing
accessory setting as described above. Please see the following chart for detail.
Mulching plug
Grass bag
Side discharge chute
Collection*
×
√
×
Mulching *
√
×
×
Side Discharge *
√
×
√
“
√
”: installed
“×”: uninstalled
* The following information:
Collection: the grass has been cut and collected by grass bag.
Mulching: mulch the grass, by cutting into small pieces which then degrade and fertilize the lawn.
Side discharge: the grass has been cut and distributed to the side of the machine.
ASSEMBLY
WARNING!
Never operate the cutting height adjustment handle roughly. Switch off the tool and
make sure that the blade has stopped completely.
Adjust the cutting height
The cutting height is centrally adjusted by the cutting height adjustment handle. Different cutting heights
can be selected as follows:
1. Pull the adjusting handle outwards. (See Fig. 12)
Fig. 12
2. Move it forwards or backwards to select the desired cutting height.
3. Return adjusting handle back into plate. Make sure the lever is secured in position. From position 1 to
position 7, the cutting height ranges from 1 1/4 -3 3/4 in.
ADJUSTMENT
