18
19
ASSEMBLY
Removing and inserting the battery pack
As shown in Fig. 3
To remove the battery pack from the tool
Press the battery pack release button downward,
And pull the battery pack toward operator, then remove it.
Fig 3
ASSEMBLY
1. Plug the plug of the adaptor to the charger base.
2. Slide the charger base onto battery pack.
3. Connect the adaptor to a power supply. The green LED Light of the adaptor will be
on.
4. Once the battery pack slide into charger base correctly .The charging procedure will
carry out. LED light of the adaptor will turn red.
5. After charging is complete, LED light of the adaptor will turn green again.
6. To remove the battery pack from charger base. Hold the charge base with one hand,
meanwhile Depress the releasing/locking button on the battery pack, pull the battery
pack out with the other hand.
The power indicator on the battery pack
As shown in Fig 5
Press the power indicator button, battery power will be showed by how many indicators
lighted, 3 lights means full.
We recommend that when it shows less than 30%, it is time to recharge the battery pack.
To insert the battery pack
1. Keep the battery pack in line with the holder on the device.
2. Push it forward until it reaches the bottom. Before starting make sure the battery pack
is firmly locked in place.
WARNING:
Make sure that the tool is “OFF”.
Charging the battery pack
As shown in Fig 4
NOTE:
The battery pack will be fully charged after 60mins .Remove it from the
charger after it has been fully charged .
NOTE:
This battery pack has been shipped in a low charge condition . it should
be fully charged before first use.
NOTE:
Make sure the main voltage is the same as rating label which located on
the adaptor.
Fig 5
Fig 4
To obtain the best life from the battery
Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down or
the tool no longer performs a task it previously performed.
Avoid conducting short charges. Make sure that the battery is fully charged every time by
allowing the charger to complete its full charging cycle.
Avoid allowing lose items like screws or nails etc. to be stored with battery packs as these
or similar items can short battery packs and cause a fire or explosion
Always unplug the charger when not in use and store in a dry secure place.
Avoid charging or storing your battery in temperatures below 0°C (32°F) and above 40°C
(104°F).
Cool down hot battery pack from a just-operated tool for approximately 30 minutes before
attempting to recharge.
