SAFETY WARNING!
INDUSTRY CANADA COMPLIANCE STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
FCC INFORMATION TO USERS
This equipment has been tested and found to comply with the limits for Class B digital
devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna;
-Increase the separation between the equipment and receiver;
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING:
Changes or modifications not expressly approved by Nautic Devices Inc.
could void the user’s authority to operate the equipment.
FOR CLASS B – UNINTENTIONAL RADIATORS
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may cause
undesired operations.
Don’t hold Yapalong too close to your head when in use.
03
10
GET STARTED
1.
Turn the Yapalong5000-CE unit on by holding down Power button for
2 seconds until Red Status LED turns on.
2.
If the Amber Status LED blinks every 2 or 5 seconds or there is no
LED light at all, the battery needs to be charged.
3.
If Red Status LED remains on with high intensity, it means it cannot
detect other group unit due to various reasons:
Ɣ
no group unit powered on;
Ɣ
group unit out of range;
Ɣ
unit in different group
(Refer to BINDING PROCEDURE
to do binding).
4.
If Red Status LED remains on
with normal intensity, it means it
has detected group unit(s). Plug in
the headset as shown. The unit is
now ready to be used with other
powered-on group units.
5.
To adjust the sound volume, click UP or DOWN button, until desired
volume is reached.
6.
To adjust the microphone sensitivity, click UP or DOWN button while
holding down MIC SENSITIVITY button, until desired sensitivity is
reached. Now Yapalongs let every member in the group talk freely and
listen at the same time.
POWER UP A GROUP
Power on one of the radios at the location where the radios to be used. Wait
until the red light of the radio becomes solid, then power on the rest radios.
Power on all the radios at the place where they will be used. It is not
recommended to power on all the radios at one location (e.g., locker
room), then use them at another (e.g., football field). This is needed because
the radios auto scan the surroundings for the cleanest channel upon being
powered on.
