FUEL SYSTEM
TNV DI Service Manual
7-29
Fuel Injection Pump
Figure 7-33
9. Apply ThreeBond Liquid Gasket No. 1212,
Yanmar Part No. 977770-01212, or equivalent
sealant to the sealing surface of the pump
cover. Install the pump cover and tighten the
cover bolts.
10. Reconnect the fuel return lines, fuel supply line
and coolant lines to the fuel injection pump.
11. Reinstall the fuel injection high-pressure lines.
Tighten the nuts to specification. See Special
Torque Chart on page 7-11.
IMPORTANT
When reinstalling a new or repaired fuel
injection pump, it is important to add engine
oil to the fuel injection pump to provide
lubrication for initial start-up. Add 5-7 oz
(150-200 cc) of clean engine oil to the fuel
injection pump at the fill plug located in the
upper outside section of the governor
housing.
12. If equipped, verify the fuel injection pump
insulator (Figure 7-34, (2)) is not damaged.
Reinstall the insulator and intake manifold if
previously removed.
Figure 7-34
13. Reinstall the coolant pump V-pulley
(Figure 7-35, (4)), spacer (Figure 7-35, (3)) (if
equipped) and engine coolant fan
(Figure 7-35, (2)).
Figure 7-35
14. Reinstall the cooling fan V-belt
(Figure 7-35, (1)). Adjust it as described in
Check and Adjust Cooling Fan V-Belt on
page 5-22.
15. Reinstall the cooling fan guard (if equipped).
0000593B
(1)
(2)
(1)
(2)
0000263A
(1)
(4)
(3)
(2)
0000163A
TNV_DI_SM_A4.book 29 ページ ２００７年１２月６日 木曜日 午前９時２３分