Operating
Manual
YZ-X9
8
Machine installation
Attach the squeegee assembly
1. Park the machine on a level ground and take out the key.
2. Lower the squeegee lift lever to the lower position.
3. Attach the squeegee to the squeegee mounting bracket as shown in the
figure. Be sure to completely place the tightening knob into the socket
before tightening the knob.
4. Connect the vacuum suction pipe to the squeegee assembly.
5. Check the squeegee rubber strip and make appropriate adjustments
Install the brush/cleaning pad
Note: For the recommended brushes and scouring pads, please refer to the "
Brush and scouring pad information" section of this manual, or
Please contact your local authorized dealer.
1. Park the machine on a level ground and take out the key.
2. Step on the brush head lifting pedal to lift the brush head off the ground
3. Put the scouring pad on the needle seat first, and then install the drive
disk. Tighten the central lock to fix the scouring pad.
4. Align the needle holder/brush mounting pin with the buckle of the motor
drive plate, and press the brush plate motor switch.
5. To remove the needle holder and brush, step on the brush head lifting
pedal to lift the brush head off the ground, and press the brush plate motor
switch.
Machine operation
For safety: Do not operate the machine before reading and understanding the
operation manual. -
Warning: Risk of fire or explosion. Do not be near or in a place with flammable
liquid, gas or flammable dust
Operate the machine.
Check before operation
□
Clean the dust on the ground.
□
Check the power scale of the battery power meter. (Refer to the battery power
meter)
□
Check the wear of the pad/brush.
□
Check the wear of the squeegee strip and adjust the angle appropriately.
□
Make sure that the sewage tank is empty and a clean floating filter has been
installed.
□
Check the wear of the brush head skirt.