13
Operating
Manual
YZ-X9
Quarterly maintenance
Check the wear of the carbon brushes of the drive motor (drive model),
vacuum motor and brush motor every 250 hours. When the length of the
carbon brush
When the wear is within 10 mm, the carbon brush needs to be replaced. If the
machine needs to be repaired, please contact an authorized service center.
Warning: Risk of electric shock. Please disconnect the battery wiring before
servicing the machine.
Handling the machine
When using a truck or trailer to move the machine, be sure to follow the
following binding procedures:
1. Raise the brush head to the carrying position.
2. Use the recommended loading dock to load the machine.
3. Place the front of the machine close to the front of the truck or trailer. After
the machine is put in place, lower the brush head and turn the key to the off
position
Set.
4. Place obstacles behind each drive wheel to prevent the machine from sliding.
5. Use ropes to secure the top of the machine to prevent tilting. You must install
a bracket on the deck of the truck or trailer. For an
For the sake of all: When moving the machine, please use the recommended
loading and unloading platform to load and unload the machine from the truck
or trailer, and secure the machine with ropes
On the car board.
Storage machine
1. Please charge the battery before storing. Do not store when the battery is
exhausted.
2. Drain and rinse the tank in the sink thoroughly.
3. Store the machine in a dry place and keep the brush head in the raised
position.
4. Open the recovery tank cover to facilitate ventilation. Note: Do not expose the
machine to rain and store it indoors.
5. If you store the machine in a cold environment, please make sure to drain all
the liquid inside the machine.