YANGZI YZ-X8, Operating Instruction

Page: 13 / 18

InstructionManual YZ-X8
11
Please use high spark or open ignition source.
Keep the battery compartment open while charging.
2. Park the machine on the level ground and turn the key to the closed position.
3. Check the electrolyte level in each battery unit before charging.
For safety reasons: When repairing the machine, please wear protective gloves and eye
protection equipment when handling battery and battery wiring.
Avoid contact with battery acid.
4. When charging, open the sewage tank to the side for ventilation
5. Plug the charger's AC(AC) power cord into a well-grounded power outlet.
6. Insert the DC line of the charger into the charging socket of the battery behind the
sewage tank.
7. The charger will automatically start charging and will automatically close when it is full.
Note: the machine will not operate when connected to the charger.
Note: During charging, do not pull out the Dc cable of the charger from the socket.
To avoid arc discharge.
If you must stop charging during the charging process, please remove the AC power cord
first.
Warning: Fire or explosion danger.
Thebatteryemitshydrogengas.
Stay away from sparks or open fires.
Keep the battery compartment open while charging.
9.After charging, check the electrolyte level again.
The machine maintenance
As long as the daily, weekly and monthly maintenance procedures are followed, the
machine can be kept in top working condition.
Warning: Electric shock hazard.
Disconnect the battery before maintaining the machine.
Daily maintenance after each use
1. Drain and clean the sewage tank
2. Remove and rinse the floating filter screen located in the sewage tank
3. Drain the clean water tank and flush the tank with hot water not higher than 60° C
as required
4. Remove the clean pad/brush for cleaning.
If there is wear, roll over or replace the clean mat
5. Wipe the absorbent paddle.
The water-absorbing gripper assembly shall be placed in the raised position to prevent
damage to the rubber strip.