YZ-X1
Instruction Manual
3
1.0 Operation safety guidance
Read this manual carefully before operating the machine.General safety reference in the
preparation, operation and maintenance of machinery
Nan describes in detail in this book that accident prevention rules must be followed
when used.If by reason of non-compliance with these rules
Causes the accident, the manufacturer will not be responsible!
This manual is also an important accessory to the machine and should ensure that the
operator can read or listen professionally before using it
Personnel to do relevant explanations, should be placed in a place can often read.The
following three ICONS are used in this guide
Important note.
Tip: Important information about economic use.Failure to follow this tip may result in
mechanical failure!
Note: Failure to follow this tip may result in mechanical failure and property damage!
Prohibition: Failure to follow this instruction may endanger persons or cause serious
damage to property!
Safety Precautions
Attempt to operate or repair the machine without reading this instruction manual may
cause harm to you or others
Capable of damaging machinery or other property.The operator must go through the
system training before using the machine to be on duty.
In order to avoid the occurrence of fire, the machine is only suitable for non-explosion-
proof grade commercial floor cleaning.
An incomplete or unassembled machine may cause injury or damage to you or others
Machinery or other property.Do not operate the machine until it is fully assembled.The
user is operating the machine
Please carefully check the integrity of the machine before using it.
Maintenance of the machine should be carried out by professionally trained personnel,
checkthemachineshouldbedisconnectedfromthepowerconnector,soastoavoid
Inadvertently enlarge the fault.
Reconnect the battery, be sure to pay attention to the polarity of the connection line
and the battery, absolutely not wrong, after the connection is completed
Check it again and again before connecting the battery connector to the machine.
