YANGZI X4, Operating Instruction

Page: 7 / 17

X4
2
Before using the machine, open the water tank cover and pour clean water into
the water tank. Pay attention to the clean water quality to prevent the waterway from
being blocked.
When the machine is used to clean the epoxy floor, it is necessary to replace the
ordinary brush plate with the needle plate and add a cleaning pad for cleaning, which
can effectively protect the ground from wear and tear. For installation, refer to "3.2
Brush plate replacement and installation" for operation.
2.2 The operation process of the machine
●Before the normal operation of the machine, make sure that the squeegee is
installed correctly, and the sewage suction pipe is inserted into the suction port.
1. Use the handle to lower the squeegee tripod;
2. Pass the squeegee fixing screw through the tripod eyelet and tighten the plastic
knob;
3. Insert the conical mouth of the suction pipe into the sewage hole of the water tank,
and insert the other end into the suction port of the squeegee.
Power display
After turning on the main power switch, the voltmeter will display the battery
voltage value. When the voltage is lower than 21V or the last bar is flashing, please
charge it first.
Start the machine
● Lightly step on the foot lever and put down the scrubbing brush;