34
VG3511-8F
7
.
Trimming mechanism
Fig. 7-1
7.1 Adjusting trimming position of fabric
Loosen the screw ① of the lower knife braket to move the
lower knife holder ② right and left.
Adjust it as follows:
(1) Loosen the screw ① .
(2) Move the lower knife holder ② at required position.
(3) Tighten the screw ① with a tightening torque of 1.5 -
2 N・m.
(4) Rotate the handwheel to check the sharpness of the
blades by setting a thread between the upper knife ③
and the lower knife ④ .
(5) Set the top of the lower knife ④ 7.0 ㎜ apart from the
upper knife ③ tip (at the base of the blade). Then,
tighten the screw ⑤ of the collar(left) ⑥ .
(6) Recheck the knifes cut properly.
Before operating, ALWAYS turn the power switch OFF and check that the machine has already stopped.
Refer to “7.2 Adjusting suction pipe(front)”
and “7.3
Adjusting suction pipe cover”
after changing trimming
position of a fabric.
ATTENTION
①
②
③
④
⑤
③
④
7.0 ㎜
stitch plate
Fig. 7-2
Summary of Contents for VG3511-8F
