20
4. Operating procedures
Operating procedures (auto stop operation)
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU
TIMER
FIXED
TEMP.
PROGRAM
PROGRAM
3. Stopping and ending timer operation
Operation stops automatically when the set time comes.
The buzzer sounds for about five seconds to indicate operation has
stopped. At this time, the character End
that indicates
operation end is displayed on the SET TEMP. display with the
AUTO STOP lamp is illuminated. Press the RUN/STOP key for
approx. one second to end the timer operation mode. The screen
switches to the initial setting screen.
When you want to
correct set
temperature or set
time, or confirm
settings
When you want change the set temperature or a set time, press the
TIMER key during operation, set temperature and time for the auto
stop operation with the
▼▲
keys and press the ENTER key to
complete.
Note, however, when you change the set time you need to set a time
calculated by adding the time already passed to the time to be added.
Pressing the
▼
key during operation will display the set temperature,
the operation mode and the remaining time on the SET TEMP. display.
In terms of the remaining time display
a blinking dot
indicates count down and an illuminating dot indicates a wait status
(while temperature is increasing or decreasing to the set temperature)
during which the timer has stopped counting.
