YCO-1102-05-02
CPS Series
Operation Manual
IV Directions for Use
4
Turning the Scale On and Off
Remove everything from the platform surface, and press the
On
Off
key. The display will briefly perform a
full segment display. After approximately three seconds, the display will automatically set to zero.
Press the
On
Off
key. The display will
go off. The scale can be programmed to automatically shut off
after 2, 3, 4, or 5 minutes of non-use, even if the
On
Off
key is not pressed. Please see section III,
“Setting the Scale Functions” to change this feature.
Low Battery Condition
The low battery indication will appear when the battery needs to be replaced. See section III, “Installing
the Battery” to replace the battery.
Zero the Display
The scale will automatically zero when turned on. If a value is displayed when the platform is empty,
push the
Tare
key to zero the display. The maximum zero range is approximately the capacity of
the scale.
Changing Units of Measurement
To cycle through g, oz, dwt, ozt and counts, press the
Unit
key. The scale will only display the units
that have been enabled in the scale set-up mode. Upon startup, the scale will default to the units
that were selected when the scale was last turned off.
