7
2. PRE-OPERATION PROCEDURES
Installation Precautions & Preparations
CAUTION!
5. DO NOT disassemble or modify.
Never attempt to disassemble or modify BM/BO units. Doing so may cause equipment
malfunction, fire or electric shock.
6. Install on a level surface.
Install unit on level and even surface. Failure to do so may cause abnormal vibrations or noise,
resulting in possible complications and/or malfunction.
7. Connect to an appropriate power source.
Use a dedicated power supply that matches electrical capacity of unit.
Electrical capacity:
BM500/BO400: 100 to 120V AC, 12.5A
BM510/BO410: 200 to 240V AC (single phase), 6.5A
NOTE)
In the unlikely event that unit does not run after turning power ON, inspect whether power
supply voltage of the main power is lower than specified, or whether other device(s) are sharing
the same supply or line. Change to a dedicated power supply if unit will not run due to low
voltage or shared power supply line.
8. Install equipment out of harm
’s way.
Unit may fall or shift in an earthquake or other unforeseen incident, resulting in personal
injury. Taking appropriate safety measures and installing unit out of harm
’s way is strongly
recommended.
Install a ventilation hood above the unit, with a fire extinguisher in close proximity.
Modification
Summary of Contents for BM510
Page 2: ......
