Yamaha YZFR3F, Owner'S Manual

Page: 42 / 106

OPERATION AND IMPORTANT RIDING POINTS
6-1
6
EAU15952
Read the Owner’s Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
EWA10272
Failure to familiarize yourself with
the controls can lea
d to loss of con-
trol, which coul d cause an acci d ent
or injury.
EAU62513
TIP
This model is equipped with:

a lean angle sensor to stop the en-
gine in case of a turnover. In this
case, the display will indicate error
code 30, but this is not a malfunc-
tion. Turn the key to “
” and then
to “ ” to clear the error code.
Failing to do so will prevent the en-
gine from starting even though the
engine will crank when pushing
the start switch.

an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
EAUN0680
Startin g the en g ine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:

The transmission is in the neutral
position.

The transmission is in gear with
the clutch lever pulled and the
sidestand up.
See page 4-20 for more informa-
tion.
1. Turn the key to “ ” and make
sure that the engine stop switch is
set to “
”.
The engine trouble warning light
should come on for a few sec-
onds, then go off.
NOTICE:
If the
warnin g li g ht d oes not g o off,
have a Yamaha d ealer check its
electrical circuit.
[ECAT1121]
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
3. Start the engine by pushing the
start switch.
U2MS70E0.book Page 1 Thursday, December 18, 2014 1:46 PM