Yamaha YZ250 2021, Owner'S Manual

Page: 81 / 148

HANDLEBAR
4-9
EAM20099
HANDLEBAR
EAM30052
REMOVING THE HANDLEBAR
1. Stand the vehicle upright on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Grip “1”
TIP
Blow in compressed air between the handlebar
or tube guide and the grip. Then remove the grip
which has become loose.
3. Remove:
• Throttle cable housing “1”
•
Throttle grip “2”
TIP
While removing the throttle cable housing, pull
back the rubber cover “3”.
EAM30053
CHECKING THE HANDLEBAR
1. Check:
•
Handlebar
Bends/cracks/damage

Replace.
WARNING
EWA13690
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAM30054
INSTALLING THE HANDLEBAR
1. Stand the vehicle upright on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Lower handlebar holder “1”
•
Washer “2”
• Lower handlebar holder nut “3”
TIP
•
Install the lower handlebar holders with them
side having the greater distance “a” from the
mounting bolt center facing forward.
• Apply the lithium soap base grease on the
thread of the lower handlebar holders.
• Installing the lower handlebar holders in the re-
verse direction allow the front-to-rear offset
amount of the handlebar position to be
changed.
• Do not tighten the nuts yet.
3. Install:
•
Handlebar “1”
• Upper handlebar holder “2”
•
Upper handlebar holder bolt “3”
TIP
• The upper handlebar holders should be in-
1
G088916
1 3 2
Upper handlebar holder bolt
28 N·m (2.8 kgf·m, 21 lb·ft)
1
2
3
T
R
.
.