10
En
CONNECTIONS
For connection, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the
connections are faulty, no sound will be heard from the subwoofer or the speakers, or both of them. Make sure that the +
and – polarity markings of the speaker cables are observed and set correctly. If these cables are reversed, the sound will
be unnatural and lack bass.
Do not let the bare speaker wires touch each other, because this could damage the
subwoofer or the amplifier, or both of them.
■
Before connecting
Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.
■
How to connect
1
Press and hold the terminal’s tab, as shown in the figure below.
2
Insert the bare wire.
3
Release your finger from the tab to allow it to lock securely on the cable’s wire end.
4
Test the firmness of the connection by pulling lightly on the cable at the terminal.
Do not insert the insulation coating into the hole. The sound may not be produced.
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
Caution
Good
No Good
10mm
(3/8”)
2
1
Black: negative (–)
Red: positive (+)
Note
