AUTO SETUP
33
SETUP
6
Press
/
/ / to select and configure
each parameter and then press ENTER.
INSTALLING (Installing)
Use to select the installed position of the unit in your
listening room.
Choices:
Parallel to Wall
(Parallel with wall
installation),
Angle to Wall or corner (Corner installation)
• Select Angle to Wall or corner if the unit is installed in
the corner. The beam mode is set to ST+3BEAM (see
page 43).
• Select Parallel to Wall if the unit is installed in parallel
with the wall. The beam mode is set to 5BEAM (see
page 43).
MOUNTING (Mounting)
Use to select the mounted position of the unit in your
listening room.
Choices:
SHELF
(Shelf mount), WALL (Wall mount)
• Select WALL if the unit is mounted on the wall.
• Select SHELF if the unit is mounted on the shelf.
REFLECTING (Reflecting)
Use to select the reflectivity of your listening room.
Choices:
NORMAL
(Normal), HI ECHO (High echo)
• Select NORMAL if your listening room has a normal
reflectivity.
• Select HI ECHO if your listening room has highly
reflective surfaces such as concrete walls.
7
Check the following points once again before
starting the AUTO SETUP procedure.
• Is the optimizer microphone firmly connected to
this unit?
• Is the optimizer microphone placed in a proper
location?
• Are there any large obstacles in between the
optimizer microphone and the walls in your
listening room?
ENTER
Angle to Wall or corner
Parallel to Wall
SHELF
WALL
