19
CABLE ROUTING
SPEC
D Align the mark on the brake hoses
with clamp, and clamp them.
E Fasten the throttle cable to the
frame with a plastic band.
Refer to fig B.
F Route the fuel tank over flow hose
through the clamp on inside of the
frame.
G Lower throttle cable is pull side.
H Upper throttle cable is push side.
I Fasten the wireharness with a
steel clamp on the frame.
J Route the rear wheel sensor as
illustration.
K Route the rear wheel sensor lead
through the guide.
L Route the carburetor air ventila-
tion hose, carburetor coolant drain
hose and carburetor drain hose
through the guide.
M Route the carburetor drain hose
through the guide.
N Route the over flow hose (fuel fill-
er) and hydraulic unit drain hose
through the guide.
O Position the connector of plastic
band as illustration.
P Position the connector of the plas-
tic band inside of the line.
Q Route the rear wheel sensor lead
through the front of the crankcase
breather hose.
R Align the white tape on the wire-
harness with the steel clamp on
the frame, and fasten them.
