YHT-34 Q
U I C K
-C
O N N E C T
G
U I D E
10
P
ROGRAMMING
T
HE
U
NIVERSAL
R
EMOTE
C
ONTROL
S
ETTING
U
P
C
OMPONENTS
Perform the procedure for each component you own.
At the end of each step 5, the remote control’s processor
will automatically assign the selected component’s
control functions to its own buttons, ready for your use.
S
ETTING
U
P
Y
OUR
TV
1. Turn on the television set and look up a setup code
for your brand of television (codes are located at the
back of the
HTR-5450 Owner’s Manual
).
2. On the remote control, press TV.
3. Press and hold both VOLUME buttons at least four
seconds until the indicator LED flashes twice.
4. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If the LED did not flash twice, repeat steps 3 and 4.
5. To verify the code works, aim the remote control at
the television set, press TV, and then press POWER.
The television set should turn off. If it doesn’t
respond, use another code for the same manufac-
turer and repeat steps 3 through 5.
The YHT-34 Home Theater package includes a univer-
sal remote control. It comes pre-programmed with
factory codes to control your HTR-5450 receiver and
most Yamaha audio components. To program other
brands of components (i.e., TV, VCR, etc.) or if your
Yamaha unit does not respond, you will need to
program the remote control with the manufacturer’s
codes (listed on the back pages of the
HTR-5450
Owner’s Manual
).
NOTE: The universal remote control is designed to control
most major brands of audio and video components. For other
units, use the original remote control supplied with the product.
P
OWER
O
N
1. Load the supplied batteries into the remote control.
2. Aim the remote control at the receiver, press AMP/
TUNER, and then press POWER.
3. The receiver should turn on.
Indicator LED
Use Keypad
To Enter
Setup Codes
Turns On
Component’s
Power
Component
Selector
Buttons
Use To Enter
Setup Mode
Use To Enter
Setup Mode
