Yamaha YFS200R 2002, Service Manual

Page: 23 / 75

– 15 –
CHK
ADJ
ADJUSTING THE REAR BRAKE
1.Check:
●
Rear brake pedal position
a
Out of specification
→
Adjust.
1
Brake pedal
2
Footrest
Brake pedal position:
0 ~ 10 mm (0 ~ 0.39 in)
2.Adjust:
●
Brake pedal position
*****************************************************
Adjustment steps:
●
Loosen the locknut
1
.
●
Turn the adjusting bolt
2
until the specified
brake pedal position is obtained.
●
Tighten the locknut
1
.
●
Adjust the rear brake light switch.
Refer to “ADJUSTING THE REAR BRAKE
LIGHT SWITCH”. (Manual No.: 2XJ-AE2)
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by
placing a block under the engine, and spin
the rear wheels to ensure there is no brake
drag. If any brake drag is noticed, perform
the above steps again.
*****************************************************
Direction
a
Brake pedal is lowered.
Direction
b
Brake pedal is raised.
Brake pedal position:
0 ~ 10 mm (0 ~ 0.39 in)
T
R
.
.
Locknut:
17 Nm (1.7 m • kg, 12 ft • lb)
2
1
2
1
a b
ADJUSTING THE REAR BRAKE