Yamaha XTZ690, Owner'S Manual

Page: 28 / 102

Instrument an d control functions
3-13
3
Ri g ht
EAU12362
Pass switch “PASS”
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to “
”, the passing switch has no ef-
fect.
EAUM4180
Dimmer switch “ / ”
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
TIP
When the switch is set to low beam,
both headlights for low beam come on.
When the switch is set to high beam,
both headlights for high beam and
both headlights for low beam come on.
EAU12461
Turn si g nal switch “ / ”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “ ”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “ ”
Press this switch to sound the horn.
EAU12663
En g ine stop switch “ / ”
Set this switch to “ ” (run) before
starting the engine. Set this switch
to “
” (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
EAU12713
Start switch “ ”
Push this switch to crank the engine
with the starter. See page 5-2 for start-
ing instructions prior to starting the en-
gine.
EAU12735
Hazar d switch “ ”
With the key in the “ON” or “ ” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
ECA10062
Do not use the hazar d li g hts for an
exten d e d len g th of time with the en-
g ine not runnin g , otherwise the b at-
tery may d ischar g e.
EAUM4090
“SELECT” switch
This switch has the same functions as
the bottom set button of the Multi-
function meter unit.
1. Engine stop switch “ / ”
2. “SELECT” switch
3. Start switch “
”
2
3
1
UBW3E0E0.book Page 13 Friday, May 24, 2019 11:01 AM