Yamaha XT600E 2000, Owner'S Manual

Page: 81 / 102

6-37
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU01008
Troubleshooting
Although Yamaha motorcycles
receive a thorough inspection before
shipment from the factory, trouble
may occur during operation. Any
problem in the fuel, compression, or
ignition systems, for example, can
cause poor starting and loss of
power.
The following troubleshooting chart
represents a quick and easy proce-
dure for checking these vital systems
yourself. However, should your
motorcycle require any repair, take it
to a Yamaha dealer, whose skilled
technicians have the necessary tools,
experience, and know-how to service
the motorcycle properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life
and can lead to expensive repair
bills.
EAU01136
To install the rear wheel
1. Install the drive chain onto the
rear sprocket, and then insert the
wheel axle from the left-hand
side.
NOTE:
8
Make sure that there is enough
space between the brake pads
before inserting the brake disc
between the brake pads.
8
Make sure that the drive chain
adjusting plates are installed with
the punched sides facing to the
outside.
3. Install the swingarm end bolts.
4. Adjust the drive chain slack.
(See page 6-23 for drive chain
slack adjustment procedures.)
5. Tighten the axle nut, brake
caliper bracket bolt and
swingarm end bolts to the speci-
fied torques.
Tightening torques:
Axle nut:
105 Nm (10.5 m 0 kg)
Brake caliper bracket bolt:
48 Nm (4.8 m 0 kg)
Swingarm end bolt:
3 Nm (0.3 m 0 kg)
3WR-9-2A (E) 6 6/28/00 11:17 AM Page 38
ProCarManuals.com