7
Connection
■
Using a Euroblock connector
1.
If the wire insertion ports are closed, turn the screws
on top of the connector counterclockwise to open the
ports.
2.
Insert the wires into the appropriate ports, following
the indication of the pole on the input terminal, turn
the screws on top of the connector clockwise to fix the
wires.
3.
Attach the Euroblock connector to the input terminal
on the unit.
■
Speaker Connection
1.
Turn off the POWER switch.
2.
Remove the cover attachment screws and remove the
protective cover from the speaker terminals.
Screw
3.
After removing approx. 15 mm of insulation from the
ends of the speaker cables, pass the bare ends of the
speaker wires through the holes in the corresponding
speaker terminals and tighten the terminals to securely
clamp the wires. Refer to page 6 for speaker porality.
15mm*
*
Shown actual size.
At this time make sure that the bare ends of the
speaker cables do not extend from the terminals in
such a way that they touch the chassis.
Wire should not
touch the chassis.
4.
Reattach the protective cover over the speaker
terminals.
+
–
G
Use a screwdriver
to fix the wires.
