PERIODIC MAINTENANCE AND ADJUSTMENT
7-20
1
2
3
4
5
6
7
8
9
erated without the air filter ele-
ment installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.
[ECA10481]
8. Place the holding clip in the origi-
nal position.
9. Close the air filter case cover, and
then install the screw.
10. Install the panel.
To clean the air filter check hose
1. Check the hose at the bottom of
the air filter case for accumulated
dirt or water.
2. If dirt or water is visible, remove
the hose, clean it, and then install
it.
EAU45353
Cleaning the spark arrester
The spark arrester should be cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
WARNING
EWA10980
Always let the exhaust system
cool prior to touching exhaust
components.
Do not start the engine when
cleaning the exhaust system.
1. Remove the spark arrester cap by
removing the spark arrester cap
bolts.
2. Remove the tailpipe by pulling it
out of the muffler, and then remove
the gasket.
3. Tap the tailpipe lightly, and then
use a wire brush to remove any
carbon deposits from the spark ar-
rester portion of the tailpipe and in-
side of the tailpipe housing.
4. Install the gasket, and then insert
the tailpipe into the muffler and
align the bolt holes.
5. Install the spark arrester cap by in-
stalling the bolts, and then tighten-
ing them to the specified torque.
1. Air filter check hose
1
1. Spark arrester cap
2. Spark arrester cap bolt
1
2
1. Tailpipe
2. Spark arrester
3. Gasket
1
2
3
32C-9-18.book 20 ページ ２０１１年７月６日 水曜日 午後５時５５分
