Yamaha WR250F 2022, Owner'S Service Manual

Page: 109 / 404

ENGINE
3-21
NOTICE
ECA24260
• Adding water instead of coolant lowers the
antifreeze content. If, therefore, water is
used instead of coolant, check, and if nec-
essary, adjust the antifreeze concentration.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
4. Start the engine, warm this up for several
minutes, and then stop it.
5. Check:
•
Coolant level
TIP
Before checking the coolant level, wait a few
minutes until the coolant has settled.
EAM30211
CHECKING THE COOLING SYSTEM
1. Remove:
•
Seat
• Side cover (left/right)
•
Air scoop (left/right)
Refer to “GENERAL CHASSIS” on page 4-1.
2. Check:
• Radiator
•
Radiator hose
Crack/damage

Replace.
Refer to “RADIATOR” on page 6-2.
3. Install:
•
Air scoop (left/right)
• Seat
•
Side cover (left/right)
Refer to “GENERAL CHASSIS” on page 4-1.
EAM30212
CHANGING THE COOLANT
WARNING
EWA13030
A hot radiator is under pressure. Therefore,
do not remove the radiator cap when the en-
gine is hot. Scalding hot fluid and steam may
be blown out, which could cause serious in-
jury. When the engine has cooled, open the
radiator cap as follows:
Place a thick rag or a towel over the radiator
cap and slowly turn the radiator cap counter-
clockwise toward the detent to allow any re-
sidual pressure to escape. When the hissing
sound has stopped, press down on the radi-
ator cap and turn it counterclockwise to re-
move.
1. Place a container under the engine.
2. Remove:
•
Engine guard
Refer to “ENGINE REMOVAL” on page 5-6.
•
Coolant drain bolt “1”
3. Remove:
•
Radiator cap
Slowly loosen the radiator cap to drain cool-
ant.
TIP
When the radiator cap is loosened, coolant will
gush out transversely; therefore, bring the con-
tainer near to the outlet.
4. Thoroughly flush the cooling system with
clean tap water.
5. Install:
• Copper washer
•
Coolant drain bolt
6. Pour coolant.
1. Radiator
Coolant drain bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Recommended coolant
High quality ethylene glycol
anti-freeze containing anti-cor-
rosion for aluminum engine
Radiator (including all routes)
0.93 L (0.98 US qt, 0.82 Imp.qt)
Coolant mixing ratio
1:1 (Coolant:Water)
1
1
Ne w
T
R
.
.