Yamaha VZ200R, Owner'S Manual

Page: 47 / 96

41
Installation
EMU26902
Installation
The information presented in this section is
intended as reference only. It is not possible
to provide complete instructions for every
possible boat and motor combination. Prop-
er mounting depends in part on experience
and the specific boat and motor combination.
WARNING
EWM01590
●
Overpowering a boat could cause se-
vere instability. Do not install an out-
board motor with more horsepower
than the maximum rating on the capac-
ity plate of the boat. If the boat does not
have a capacity plate, consult the boat
manufacturer.
●
Improper mounting of the outboard mo-
tor could result in hazardous condi-
tions such as poor handling, loss of
control, or fire hazards. For permanent-
ly mounted models, your dealer or oth-
er person experienced in proper
rigging should mount the motor.
EMU33470
Mounting the outboard motor
The outboard motor should be mounted so
that the boat is well balanced. Otherwise, the
boat could be hard to steer. For single-en-
gine boats, mount the outboard motor on the
centerline (keel line) of the boat.
EMU26953
Mounting height
To run your boat at optimum efficiency, the
water resistance (drag) of the boat and out-
board motor must be made as little as possi-
ble. The mounting height of the outboard
motor greatly affects the water resistance. If
the mounting height is too high, cavitation
tends to occur, thus reducing the propulsion
and causing the engine to overheat. If the
mounting height is too low, the water resis-
tance will increase and thereby reduce en-
gine efficiency. Mount the outboard motor so
that the anti-cavitation plate is about 130 mm
(5 in) above the bottom of the boat.
NOTICE
ECM01631
●
Check that the idle hole stays high
enough to keep out water getting inside
1. Center line (keel line)
1
ZMU01873
ZMU02098
130 mm (5 in)