Yamaha Virago XV535, Owner'S Manual

Page: 72 / 96

PERIODIC MAINTENANCE AND MINOR REPAIR
6-35
6
EAU01394
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
NOTE:
_
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
_
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Push down hard on the handlebar
several times to check for proper
fork operation.
6. Tighten the wheel axle to the
specified torque.
7. Install the front wheel axle pinch
bolt, and then tighten it to the
specified torque.
8. Connect the speedometer cable.
EAU01337
Rear wheel
To remove the rear wheel
EW000122
WARNING
_
●
It is advisable to have a Yamaha
dealer service the wheel.
●
Securely support the motor-
cycle so that there is no danger
of it falling over.
_
1. Remove the axle nut cotter pin,
and then loosen the axle nut.
1. Retainer
Tightening torque:
Wheel axle:
58 Nm (5.8 m·kg)
Tightening torque:
Front wheel axle pinch bolt:
23 Nm (2.3 m·kg)
1. Axle nut cotter pin
2. Axle nut
E_3bt.book Page 35 Thursday, September 7, 2000 10:01 AM