PERIODIC MAINTENANCE AND MINOR REPAIR
6-34
6
EAU24210
Replacing a turn signal light
bulb
1. Remove the turn signal lens by re-
moving the screws.
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
CAUTION:
ECA10680
Do not overtighten the screws, oth-
erwise the lens may break.
EAU24350
Supporting the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
1. Screw
1. Turn signal light bulb
U2UJ1DE0.book Page 34 Thursday, May 13, 2004 11:59 PM
Summary of Contents for VIRAGO XV250T
Page 1: ...2UJ 28199 1D LIT 11626 18 21 XV250T XV250TC OWNER S MANUAL ...
Page 2: ...EAU10041 U2UJ1DE0 book Page 1 Thursday May 13 2004 11 59 PM ...
Page 90: ...CONSUMER INFORMATION 9 8 9 U2UJ1DE0 book Page 8 Thursday May 13 2004 11 59 PM ...
Page 95: ...PRINTED IN JAPAN 2004 05 0 6 1 CR E PRINTED ON RECYCLED PAPER YAMAHA MOTOR CO LTD ...
