INSP
ADJ
8
ELECTRICAL
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine from the wall at a dis-
tance
indicated by the chart below.
3. Measure the distance from the floor to the
center of the headlight
and place a mark
on the wall equal to distance
from the
floor.
4. With a person sitting on the machine, apply
the parking brake, start the engine and let it
idle.
5. Turn the headlight to high beam and check
the headlight projection height on the wall.
The projection should be at the parallel
mark on the wall
to 1/2° down
from
the mark. If not, adjust the headlight angle.
: Distance
: Height
: Set range
6. Adjust:
• Headlight beam (vertically)
Vertical adjustment
Higher Turn the adjusting screw
counter clockwise.
Lower Turn the adjusting screw
clockwise.
3.0 m (10 ft)
7.6 m (25 ft)
26 mm (1.0 in)
66 mm (2.6 in)
HEADLIGHT BEAM ADJUSTMENT
