INSTALLING THE INCLUDED PARTS
– 7 –
79
Turn the button cell battery cover
d
on the back
of the display unit
b
in direction
e
, remove it,
then install the button cell battery
1
.
Mount the button cell battery cover
d
, then turn
it in direction
f
until it locks.
After installing the button cell battery, install the
display unit onto the bracket following the
removal procedure in reverse order.
Peel off the protective film after installing.
5. Installing the display unit
Pass the display of the display unit
a
from
behind through the gap above the intersection
of the front and rear brake hoses and shift
wires.
As shown in the illustration, install the bracket
part of the display unit
a
to the side of the han-
dlebar holder
b
and tighten the bolts
c
to the
specified torque.
6. Installing the headlight
Install the headlight
a
to the bracket
b
of the
display unit, then tighten the bolt
c
to the spec-
ified torque.
TIP
Install in such a way that the headlight points down-
ward from horizontal and shines on the road
approximately 33 feet (10 meters) ahead.
d
e
f
1
b
g
1
Button cell battery
1
B
8
Install the button cell battery with the plus
(+) mark facing upward.
8
Check that the O-ring
g
is properly
installed.
NOTICE
a
c
a
b
Tightening torque 4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
a
b
c
Tightening torque 7 N·m (0.7 kgf·m, 5.2 lb·ft)
