SOLENOID VALVE SYSTEM
6-12
EC650001
SOLENOID VALVE SYSTEM
EC651021
INSPECTION STEPS
If the solenoid valve will not operate, use the following inspection steps.
ELEC
*1 marked : Refer to “IGNITION SYSTEM” section.
*2 marked : Refer to “BATTERY INSPECTION” section in the CHAPTER 3.
NOTE:
• Remove the following parts before inspection.
1) Cowling
4) Induction guide (right cylinder)
2) Fuel tank
5) Seat
3) Induction cap (left cylinder)
• Use l2V battery in this inspection.
• Use the following special tools in this inspection.
Pocket tester:
YU-3112-C/90890-03112
A
*2 Check battery
Recharge or replace.
OK
No good
*1 Check fuse.
Replace fuse and
check wireharness.
OK
No good
Repair or replace.
Check each coupler and
wire connection.
No good
OK
*1 Check main switch.
Replace.
OK
No good
Check solenoid valve
operation.
Check solenoid valve coil.
No good
Replace.
No good
Replace CDI unit.
OK
