Introduction
- 8 -
Owner’s Manual
Tio1608-D
Introduction
Thank you for purchasing the Yamaha Tio1608-D I/O rack.
The Tio1608-D is an I/O rack that features 16 channels of
analog inputs and 8 channels of analog outputs.
In order to take full advantage of this product's features, and
to enjoy years of trouble-free use, please read this
document before you begin using the product. After you
have read this document, please keep it in a safe place.
Main features
•
Quick Config makes it easy to create a system based
on the Yamaha TF Series Digital Mixing Console
Simply install an NY64-D card into your TF series mixing
console, and then use Quick Config to create a system
using up to three Tio1608-D racks.
•
Remote control of the built-in head amps
You can use a TF series mixing console or other
compatible device to control the built-in head amps.
•
Combination jacks provide versatile connectivity
The analog inputs use combination jacks that allow for a
wide range of applications.
Updating the firmware
The firmware contained in this product can be updated to
take advantage of new features, feature improvements, and
bug fixes. The product uses two types of firmware.
• Main unit firmware
• Dante module firmware
Details about updating the firmware are available online.
http://www.yamahaproaudio.com/
For information about updating and setting up the console,
please refer to the firmware update guide available on the
website.
Dante support
This product uses the Dante digital audio network protocol
to send and receive audio signals. Dante is a protocol
developed by Audinate that is designed to deliver
multichannel audio signals at various sampling and bit
rates, as well as device control signals over a Gigabit
Ethernet network.
For information about Dante, please visit the Audinate
website.
http://www.audinate.com/
You can also find information about Dante and Dante-
compatible products on the Yamaha Pro Audio website.
http://www.yamahaproaudio.com/
Precautions when
rackmounting
This product is designed to function in environments with a
temperature of 0 to 40°C. If you install this product together
with multiple units of the same device or other devices in a
standard EIA rack, the heat produced by the devices may
raise the ambient temperature inside the rack enclosure to
the point where performance is affected. To ensure that the
heat produced by this product can be dissipated
appropriately, please ensure the following conditions when
rackmounting it.
• When mounting the unit in a rack with devices such as
power amplifiers that generate a significant amount of
heat, leave at least 1U of unused space between the unit
and the other device.
Additionally, install a ventilation panel in this unused
space or leave it open to ensure adequate cooling.
• To ensure sufficient airflow, leave the back of the rack
open and position it at least 10 centimeters from walls or
other surfaces.
If the back of the rack cannot be left open, install a
commercially available fan or similar ventilating option to
secure sufficient airflow.
If you install a fan kit, there may be cases in which closing
the back of the rack will produce a greater cooling effect.
Refer to the documentation included with the rack and/or
fan unit details.
Recessed Installation
If you want to recess the front panel surface of the device
from the front edge of the rack, you can adjust the position
of the rack mount brackets to recess the device by 50mm,
as shown in the illustration below.
NOTE
When updating this product's Dante module firmware, make sure
you also update the Dante module firmware contained in other
connected devices.
NOTE
When you install the brackets, use the same screws that you just
removed.
50 mm
Summary of Contents for Tio1608-D
Page 4: ... 4 Owner s Manual Tio1608 D ...
Page 18: ... 18 Bedienungsanleitung Tio1608 D ...
Page 22: ......