Instrument an
d
control functions
5-6
5
Use extra caution to avoi
d
pos-
si
b
le wheel lock
d
urin
g
emer-
g
ency
b
rakin
g
.
Have a Yamaha
d
ealer check
the vehicle as soon as possi
b
le.
EAUA0911
ABS OFF in
d
icator li
g
ht “
”
This indicator light comes on when the
anti-lock brake system has been man-
ually disabled, the ABS mode indicator
comes on at the same time.
TIP
The ABS will remain disabled until:
The main switch is turned off.
The Stop/Run/Start
switch “
/
/
” is turned to
off “
” while the engine is run-
ning.
The “ABS ON” button is pressed
while the vehicle is not moving.
The ABS is reactivated via the
menu system while the vehicle is
not moving.
WARNING
EWA21100
Always ri
d
e on pave
d
roa
d
s with the
ABS turne
d
on. Turn the ABS off only
when ri
d
in
g
on non-pave
d
surfaces.
EAU92710
Immo
b
ilizer system in
d
icator
li
g
ht “
”
When the main switch is turned off and
30 seconds have passed, the indicator
light will flash steadily to indicate the
immobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
lizer system is still enabled.
TIP
When the vehicle is turned on, this light
should come on for a few seconds and
then go off. If the light does not come
on, or if the light remains on, have a
Yamaha dealer check the vehicle.
Transpon
d
er interference
If the immobilizer system indicator light
flashes in the pattern, slowly 5 times
then quickly 2 times, this could be
caused by transponder interference. If
this occurs, try the following.
1. Make sure there are no other im-
mobilizer keys close to the main
switch.
2. Use the code re-registering key to
start the engine.
3. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
4. If one or both of the standard keys
do not start the engine, take the
vehicle and all 3 keys to a Yamaha
dealer to have the standard keys
re-registered.
UBVWE0E0.book Page 6 Friday, July 14, 2023 3:12 PM
