Hauptständer TRIUMPH Tiger 955i
Centre Stand Modell 2005 –
HPS.11.531.100
Revision: 00
Montagehinweise
Mounting Instructions
M6
M8
M10
9,6 Nm
23 Nm
46 Nm
Centerstand cornering clearance:
SW-MOTECH centerstands are carefully designed and
tested to eliminate reductions in cornering clearance
and ground clearance under most driving conditions
on an unmodified stock motorcycle, and are certified
to be compliant with European ABE safety standards.
Use of any centerstand may reduce corning clearance
or ground clearance under extreme driving situations.
SW-MOTECH products should be installed by a qualified,
experienced motorcycle technician. If you are unsure
of your ability to properly install a product, please
have the product installed by your local motorcycle
dealer. SW-MOTECH takes no responsibility for damages
caused by improper installation.
All screws, bolts and nuts, including all replacement
hardware provided by SW-MOTECH, should be tightened
to the torque specified in the OEM maintenance manual
for your motorcycle. If no torque specifications are
provided in the OEM maintenance manual, the following
torques may be used:
All screws, bolts and nuts should be checked after
driving the first 50 km to ensure that all are tightened
to the proper torque.
Medium strength liquid thread-locker (i.e., "Locktite")
should be used to secure all screws, bolts and nuts.
M6
M8
M10
9,6 Nm
23 Nm
46 Nm
Alle vom Motorrad gelösten Schrauben sind gemäß
Herstellerangaben wieder zu montieren, oder mit von
SW-MOTECH gelieferten Schrauben zu ersetzen. Falls
nicht anderweitig definiert, diese Schrauben nach
Tabelle anziehen.
Gegebenenfalls Schrauben mit flüssiger
Schraubensicherung einkleben.
Prüfen Sie nach 50 km alle Verbindungen auf festen
Sitz.
Die Kurvenfreiheit kann durch einen Hauptständer
eingeschränkt werden
SW-MOTECH GmbH & Co. KG
Bahnhofstrasse 44d
35282 Rauschenberg
-Germany-
Tel.: ++ 49 (0) 6425 816 800
Fax: ++ 49 (0) 6425 816 810
www.sw-motech.com
1
Hauptständer
Centre Stand
HPS.11.258.900-01
Anzahl/
Pcs.
1
2
Befestigungsblech
rechts
Fixing Lug right
HPS.11.531.001/2
Anzahl/
Pcs.
1
3
Befestigungsblech
links
Fixing Lug left
HPS.11.531.901-01
Anzahl/
Pcs.
1
4
Zugfeder-Satz
Spring Set
ZFD.00.150.005/ST
Anzahl/
Pcs.
1
5
Innensechskant-
schraube
Hexagon Socket
Screw
M8 x 70 DIN 912
Anzahl/
Pcs.
2
6
Unterlegscheibe
Washer
A 8,4 DIN 125
Anzahl/
Pcs.
2
