Yamaha Tenere 700 2020, Service Manual

Page: 251 / 472

CRANKCASE
5-64
NOTICE
ECA20890
Do not use a torque wrench to tighten the
bolt to the specified angle.
TIP
Tighten the bolts in the tightening sequence cast
on the crankcase.
8. Tighten:
• Crankcase bolts “7”–“27”
TIP
• Tighten the bolts “7”–“16” in the tightening se-
quence cast on the crankcase.
• Tighten the bolts “17”–“27” in any tightening
sequence using a crisscross pattern.
EAS31071
INSTALLING THE OIL PRESSURE SWITCH
1. Install:
• Oil pressure switch “1”
• Oil pressure switch lead “2”
2. Apply:
• Sealant
(onto the oil pressure switch threads)
TIP
• Apply Three bond No.1215® to the threads “a”
of the oil pressure switch. However, do not ap-
ply Three bond No.1215® to the portion “b” of
the oil pressure switch.
• Install the oil pressure switch lead so that it is
routed within the range shown in the illustra-
tion.
T
R
.
.
Crankcase bolts “7”–“14”
24 N·m (2.4 kgf·m, 18 lb·ft)
Crankcase bolts “15”–“27”
10 N·m (1.0 kgf·m, 7.4 lb·ft)
×5 ×1
5
4
1
2 6
3
T
R
.
.
Oil pressure switch
15 N·m (1.5 kgf·m, 11 lb·ft)
Oil pressure switch lead bolt
1.8 N·m (0.18 kgf·m, 1.3 lb·ft)
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
×8
×3
×2
×2
×6
11
10
7
8
13
16
12
9
20
19
15
21 22
17
18
14
26 27
24 23
25