English
Initialization
SWR2310-28GT SWR2310-18GT SWR2310-10G
35
°
Using the cold start command to restore the factory settings
You can return the unit to its factory settings by using a command line setting via the
CONSOLE port, Telnet, or an SSH client.
Here we assume that you are logged in as described in “Logging in from a computer
connected to the CONSOLE port” (page 29).
1.
Enter enable, and press the <Enter> key.
You are now in privileged EXEC mode.
2.
Enter the cold start command, and press the <Enter> key.
You will be asked to enter the administrative password.
If a password has already been specified, enter the password.
When the unit is shipped from the factory, a password has not been specified, so it need not
be entered.
3.
Press the <Enter> key.
The unit returns to the factory-set state, and then restarts.
°
Entering the [I] (uppercase I) key during startup to restore the factory
settings
The unit can be restored to its factory settings by entering an uppercase “I” when the unit
is starting up. This explanation uses the method of disconnecting and reconnecting the
power cord. The procedure is also the same when using the reload command to restart
this unit.
Notice
Here we assume that you are logged in as described in “Logging in from a computer
connected to the CONSOLE port” (page 29).
1.
Disconnect and then reconnect the power cord of this unit.
2.
After restart, enter an uppercase “I” within one second after the BootROM
Ver (see below) appears on the console screen.
Memo
Before the BootROM Ver appears on the console screen, you can press the [Caps Lock] key or
hold down the [Shift] key so that you will be ready to enter an uppercase “I” immediately.
3.
When a screen asks you whether to execute initialization, press the <y> key
to execute initialization.
Initialization is executed.
SWR2310>enable
SWR2310#
SWR2310#cold start
Password:
SWR2310 BootROM Ver.1.00
Initialize or not ?(y/n)
Ready to Initialize
...............
