English
SWR2100P-10G/SWR2100P-5G Owner’s Manual
17
Attaching the rack mount
This section explains how to attach an optional RK-SWR rack mount accessory to the unit.
Please read before mounting the unit into a rack
This unit is guaranteed to operate properly at 0–40 degree Celsius (32–104 degrees
Fahrenheit). If you install this unit along with other devices into an EIA-standard rack, the
temperature inside the rack may rise due to heat released from the other devices, resulting
in poor performance of the unit. To prevent the temperature inside the rack from rising,
mount the unit in the rack, adhering to the requirements below:
• If you plan to rack-mount the unit along with a device that tends to generate heat,
such as an amplifier (excluding an XMV series), be sure to leave a gap of 1U or
more from such devices. Also, be sure to maintain sufficient ventilation in this space
by installing a ventilation panel or leaving it open.
• Open the rear panel of the rack, place the rack 10 cm (about four inches) away from
the walls and ceiling to keep sufficient ventilation. If you cannot open the rear panel of
the rack, install a commercially-available forced ventilation device, such as a fan kit. If
you install a fan kit, closing the rear panel may work better for heat dissipation
purposes. For more information, refer to the owner’s manual for the rack and/or fan kit.
If you plan to relocate the unit, be sure to first remove it from the rack. Moving the unit
along with the rack could cause the unit to malfunction.
Caution
If you plan to relocate the rack, be sure to first remove this unit from the rack.
If you move the rack with this unit mounted, vibration or physical shock might cause the rack
mount accessory to deform or break, possibly causing injury.
There is also a possibility that this unit might malfunction.
[Installation]
This section explains how to attach the unit in the middle block of a rack mount panel.
Even if you plan to attach the unit in the left or right block, follow the procedure below.
Notice
If the supplied feet have already been attached to the unit, remove them.
1.
Attaching the rack mount
panel to the unit
Use two screws (supplied with
the rack-mount accessory) to
attach and secure the rack
mount panel to the bottom of
the unit.
Rack mount panel
Screws
