Yamaha S08 Voice Editor, Owner'S Manual

Page: 64 / 88

64
Basics Section Quick Guide Reference Appendix
18 SndVar
→
Rev Send Variation To Reverb Determines the send level of the signal sent from the Variation Effect to the Reverb Effect. 47 *20
19 SndVar
→
Cho Send Variation To Chorus Determines the send level of the signal sent from the Variation Effect to the Chorus Effect. 47 *20
20 MW VarCtl MW Variation Control Depth Each Variation Effect type has a specific fixed parameter that can be controlled in realtime with the MW
or AC1. (Refer to the Effect Parameter List in the separate Data List.) 37 *21
21 AC1VarCtl AC1 Variation Control Depth 37
Part...Settings of individual 16 parts
[MULTI]
→ → → →
Multi Selection
→ → → →
[EDIT]
→ → → →
[+] or [-]
Settings...MIDI Data Table 2-8 in the separate Data List
VOICE
1 Voice
Selection Bank Select MSB/LSB, Program Number Assigns a Voice to each Part. 31 *22
MIX
2 Volume Volume Adjusts the output level of each Part. 44
3 Pan Pan Determines the Stereo Pan position. (Rnd: Pan position moves randomly each time a key is played) 28
4 -1/-2 NtLmt-L/H Note Limit Low/High Determines the lowest and highest notes of the keyboard range. 28
5 -1/-2 VelLmt-L/H Velocity Limit Low/High Determines the minimum and maximum values of the velocity range within which each Part will respond. 42
GENERAL
6 Rcv Ch MIDI Receive Channel Each Part receives MIDI messages according to the channel set here. Select “off” for Parts that you do not
want to respond to MIDI. 28 *23
7 -1/-2 NoteShift/
Detune Note Shift/Detune For Note Shift: Determines the pitch (key transpose) setting in semitones (12: one octave). For Detune:
Determines the fine tuning. *24
8 Mono/Poly Mono/Poly Selects whether each part is played back monophonically (single notes only) or polyphonically (multiple
simultaneous notes). 22
9 Part Mode Part Mode Determines whether the Part uses Normal Voices (norm) or Drum Voices (drum). 22
TONE
10 -1 VelSnsDpt Velocity Sensitivity Depth Determines the velocity sensitivity , or how much the level of the voice changes in response to your
playing strength (velocity). 39 *1
-2 VelSnsOfs Velocity Sensitivity Offset Determines the amount by which received velocities are adjusted for the actual velocity effect. 39
11 -1 Cutoff Filter Cutoff Frequency Determines the cutoff frequency for the low pass filter. 43
-2 Resonance Filter Resonance Determines the amount of filter resonance or emphasis of the Cutoff Frequency. 43
12 -1 Attack Tm Attack Time Controls how the tone (filter) or volume (amplitude) changes from the moment a note is pressed on the
keyboard to the moment it is released, or the point at which the level has faded to zero. *25
-2 Decay Tm Decay Time
-3 Releas Tm Release Time
Selected
by Selected
by
Display Parameter Name Explanation
Related
Page
Multi Edit Common / Part