114
En
Remote control features
You can clear all changes made in each function set, such
as learned functions, macros, renamed input area names
and setup remote control ID.
■
Clearing function sets
1
Set the operation mode selector to
D
AMP
or
D
SOURCE
and then press
M
CLEAR
by
using a ballpoint pen or similar object.
“CLEAR” appears in the display window (
B
).
If you do not complete each of the following steps within 30
seconds, the clearing mode will be automatically canceled.
In this case, start over from step 1.
2
Press
4
k
/
n
to select the clear mode.
L;CD (etc.) (L; Name of an input area) Clears all learned
functions in the respective input area. The name
of a component is shown after a semicolon (;).
Press an input selector button to select the input
area.
L;AMP
Clears all learned functions for controlling the
amplifier functions of this unit.
L;ALL
Clears all learned functions.
M;ALL
Clears all programmed macros.
RNAME
Clears all renamed source names.
FCTRY
Clears all remote functions and returns the
remote to the factory settings.
3
Press and hold
M
CLEAR
again for about 3
seconds.
“WAIT” appears in the display window (
B
). If
clearing was successful, “C;OK” appears in the
display window (
B
) on the remote control.
y
Once you have cleared a learned function for a button, the button
reverts to the factory setting (or to the manufacturer setting, if you
have set remote control codes).
• “L;ALL” and “FCTRY” may take about 30 seconds to
complete.
• “C;NG” appears in the display window (
B
) if clearing was
unsuccessful. In this case start over from step 2.
• “ERROR” appears in the display window (
B
) if you press a
button not indicated in the respective step, or if you press more
than one button simultaneously.
4
Press
M
CLEAR
again to exit.
Clearing configurations
Note
CLEAR
TV
SOURCE
AMP
TV
SOURCE
AMP
or
A-E/CAT.
PRESET/CH
ENTER
Notes
CLEAR
