60
TROUBLESHOOTING
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed
below or if the instruction below does not help, set this unit to standby mode, disconnect the power cord, and contact the
nearest authorized YAMAHA dealer or service center.
■
General
Problem
This unit fails to turn
on when STANDBY/
ON (or SYSTEM
POWER) is pressed,
or enters in standby
mode soon after the
power has been
turned on.
On-screen display
does not appear.
No sound.
The picture does not
appear.
Cause
The power cord is not connected or the
plug is not completely inserted.
The IMPEDANCE SELECTOR switch on
the rear panel is not fully set to either the
left or right position.
The protection circuitry has been
activated.
This unit has been exposed to a strong
external electric shock (such as lightning
and strong static electricity).
The setting for the on-screen display is set
to “DISPLAY OFF”.
The GRAY BACK setting under
“OPTION 1 DISPLAY SET” on the set
menu is set to OFF, and no video signal is
currently being received.
Incorrect input or output cable connec-
tions.
No appropriate input source is selected.
The speaker connections are not secure.
The main speakers have not been selected
properly.
The volume is turned down.
The sound is muted.
Digital signals which this unit cannot
reproduce are being received from a
source component e.g; a CD-ROM.
The output and input for the picture are
connected to different types of video
jacks.
Remedy
Connect the power cord firmly.
Set the switch fully to the left or right position when
this unit is in standby mode.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection is not touching anything other than
its respective connection.
Set this unit in standby mode, disconnect the power
cord, plug it back in after 30 seconds, then use it
normally.
Select the full display or short display mode.
Set GRAY BACK to AUTO to always show the OSD.
Connect the cables properly. If the problem persists,
the cables may be defective.
Select an appropriate input source with INPUT or
6CH INPUT (or the input selector buttons).
Secure the connections.
Select the main speakers with SPEAKERS A and/or
B.
Turn up the volume.
Press MUTE or any operation buttons on the unit to
cancel mute and adjust the volume.
Play a source whose signals this unit can reproduce.
Connect components using the same type of video
jacks (S VIDEO, VIDEO (composite), or COMPO-
NENT VIDEO) for both the input and output.
Refer to
page
–
16
16 – 17
–
19
44
10 – 17
23
16 – 17
23
24
–
–
10 – 11
0111RX-V740_60-66_EN-U.p65
03.1.10, 6:37 PM
60
