En
3
Connecting speaker cables
Speaker cables have two wires. One is for connecting
the negative (-) terminal of the unit and the speaker, and
the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive.
1
Remove approximately
10 mm of insulation from
the ends of the speaker
cable, and twist the bare
wires of the cable
together firmly.
2
Loosen the speaker
terminal.
3
Insert the bare wires of the cable into the gap on the
side (upper right or bottom left) of the terminal.
4
Tighten the terminal.
Using a banana plug
1
Tighten the speaker
terminal.
2
Insert a banana plug into
the end of the terminal.
1
Connect the front speakers (
/
)
to the FRONT (
/
) terminals.
2
Connect the center speaker (
) to the
CENTER terminal.
3
Connecting the speakers/subwoofer
• This unit is configured for 8-ohm speakers at the factory. When
connecting 6-ohm speakers, set the speaker impedance of this
unit to “6
Ω
MIN”. For details, see “Setting the speaker
impedance” (p.16) in “Owner’s Manual”.
• Use a subwoofer equipped with built-in amplifier.
• Remove the power cable of this unit from an AC wall outlet and
turn off the subwoofer before connecting the speakers.
• Be careful that the core of the speaker cable does not touch
anything or come into contact with the metal areas of this unit.
This may damage this unit or the speakers. If the speaker
cables short circuit, “CHECK SP WIRES” will appear on the
front display when this unit is turned on.
FR
ONT
– (black)
+ (red)
FRO
NT
Banana plug
SPEAKERS
FRONT
CENTER
SURROUND
SURROUND BACK/BI–AMP
R
L
R
R
L
L
SINGLE
SUBWOOFER
SINGLE
ZONE 2/
PRESENCE
EXTRA SP
R
L
This unit (rear)
SPEAKERS
FRONT
CENTER
SURROUND
SURROUND BACK/BI–AMP
R
L
R
R
L
L
SINGLE
SUBWOOFER
SINGLE
ZONE 2/
PRESENCE
EXTRA SP
R
L
This unit (rear)
