- 3 -
1
1
Connect the speakers
CENTER
SURROUND
SINGLE
SURROUND BACK/
BI-AMP
HDMI 3
HDMI 4
FRONT
SUBWOOFER
AUDIO
PRE OUT
OUT
SPEAKERS
6.1
7.1
7.1
Front speaker
R L
Surround back
speaker
R L
Surround
speaker
R L
Subwoofer
Center speaker
Connecting speakers
Connecting the banana plug
(Except U.K., Europe, Asia and Korea
models)
Tighten the knob, and then insert the banana plug
into the end of the terminal.
Banana plug
FR
ON
T
Connecting the subwoofer
1
Connect the subwoofer input jack to the SUBWOOFER
jack on this unit with an audio pin cable.
2
Set the subwoofer volume as follows.
Volume: Set to approximately half volume (or slightly less than
half).
Crossover frequency (if available): Set to maximum.
Subwoofer examples
VOLUME
MIN
MAX
CROSSOVER/
HIGH CUT
MIN
MAX
This unit can connect speakers that support Bi-amp connection for
front speakers. Refer to “Owner’s Manual” for the details.
7.1
Connect when using with 7.1-channel speaker layout.
6.1
Connect when using with 6.1-channel speaker layout.
FR
ON
T
2
2
3
1
4
4
1
Remove approximately 10 mm of insulation from
the ends of the speaker cables, and twist the bare
wires of the cables together fi rmly so that they will
not cause short circuits.
2
Loosen the speaker terminals.
3
Insert the bare wire of the speaker cable into the
gap on the side of the terminal.
4
Tighten the terminal.
Caution:
Remove the AC power cable of this unit from the power outlet
•
before connecting the speakers.
Generally speaker cables consist of two parallel insulated
•
cables. One of these cables is a different color, or has a
line running along it, to indicate different polarity. Insert the
different colored (or lined) cable into the “+” (positive, red)
terminal on this unit and the speakers, and the other cable into
the “-” (minus, black) terminal.
Be careful that the core of the speaker cable does not touch
•
anything or come into contact with the metal areas of this
unit. This may damage this unit or the speakers. If the speaker
cables short circuit, “CHECK SP WIRES!” will appear on the
front panel display when this unit is switched on.
(U.S.A. and Canada models only) When connecting 6 Ω
•
speakers, set the speaker impedance to 6 Ω on this unit before
making connections. Refer to Owner’s Manual for information
on settings.
