Introduction
Preparations
Basic Operation
Advanced
Operation
Additional
Information
Appendix
32
4
4
Press
MEMORY (MAN’L/AUTO FM)
.
The station band and frequency appear in the display with the preset group
and number you selected.
5
5
Repeat steps 1 through 4 to store other stations.
You can store up to 40 stations (A1~A8, B1~B8, C1~C8, D1~D8, and
E1~E8).
AM/FM Tuner
MEMORY
MAN'L/AUTO FM
A-1:FM 89.0 MHz
STEREO
MEMORY
D-TV/LD
DVD
CABLE
MD/TAPE
SAT
CD-R
VCR 1
TUNER
VCR2/DVR
CD
V-AUX
PHONO
Shows the displayed station has been
programmed to A-1.
Exchanging Preset Stations
You can exchange the stations stored on two preset numbers. The example below
describes the procedure for exchanging the stored stations at preset numbers E1 and
A5.
1
1
Tune to the E1 preset station number.
See “Tuning to Preset Stations.”
2
2
Press and hold
PRESET/TUNING (EDIT)
for more than 3 seconds.
“E-1” flashes in the display.
3
3
Tune to the A5 preset station number.
See “Tuning to Preset Stations.”
A-5 flashes in the display.
4
4
Press
PRESET/TUNING (EDIT)
again.
The stations stored at the two preset locations are exchanged.
Notes:
• The memory back-up circuit prevents the stored data from being lost even if this
unit is set to standby mode, the power cord is disconnected from the AC outlet, or
power service is temporarily cut due to power failure. However, if the power is cut
for more than one week, the memory may be deleted.
• Any stored station data existing at a preset number is cleared when you store a new
station at that preset number.
• The reception mode (stereo or monaural) is stored along with the station frequency.
PRESET
/TUNING
EDIT
E-1:FM
A-5:FM
PRESET
/TUNING
EDIT
EDIT
E1-A5
STEREO AUTO
D-TV/LD
DVD
CABLE
MD/TAPE
SAT
CD-R
VCR 1
TUNER
VCR2/DVR
CD
V-AUX
PHONO
Shows the exchange of stations is completed.
