9
8
En
Remote control features
Use the supplied simplified remote control to make basic controls of this unit.
■
Setting the controlling zone of the
simplified remote control
Use this feature to set the controlling zone (page 100) and
remote control ID (page 102) of the simplified remote
control.
Setting the remote control ID
• ID1: Press and hold
b
and 1 for 3 seconds.
• ID2: Press and hold
b
and 2 for 3 seconds.
Setting the controlling zone
• Main zone: Press and hold
a
and 1 for 3 seconds.
• Zone 2: Press and hold
a
and 2 for 3 seconds.
• Zone 3: Press and hold
a
and 3 for 3 seconds.
■
Replacing the battery in the simplified
remote control
Change the battery when the operation range of the
simplified remote control decreases.
• Insert the battery according to the polarity markings
(+ and –).
• If the batteries run out, immediately remove them from the
simplified remote control to prevent an explosion or acid leak.
• If a battery starts leaking, dispose of it immediately. Be careful
not to let the leaking battery acid touch your skin or clothing.
• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
Simplified remote control
INPUT
MUTE
INT SOURCE
PRESET
SYSTEM MEMORY
4
1
3
2
POWER
STANDBY
VOLUME
STANDBY
Sets the selected zone to the
standby mode.
SYSTEM MEMORY
Save or recall the system
settings.
INPUT
l
/
h
Select the input source.
/–
Recall the preset FM/AM
stations, XM channels or
SIRIUS channels.
s
(stop) /
p
(play) /
b
(skip backward) /
a
(skip forward)
Control playback of the
iPod.
POWER
Turn on the power.
/–
Adjust the volume level.
MUTE
Mutes the audio output.
Remove the insulation sheet before using the remote
control.
Notes
Use a straight
pin to remove
the cover.
Replace the
battery with a
new CR2025
battery.
Close the
cover.
Summary of Contents for RX-V1900BL
Page 133: ......