37
En
Playback
BA
S
IC
OPERA
T
ION
English
Press
K
MUTE
on the remote control to mute the
audio output. Press
K
MUTE
again to resume
the audio output.
y
• The VOLUME level indicator flashes while the mute function is
on.
• You can configure the muting level with “MUTING TYPE”
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
1
Set the operation mode selector to
E
AMP
and then press
H
MENU
on the remote
control.
The top “SET MENU” screen appears in the OSD.
2
Press
8
n
repeatedly to select “SIGNAL
INFO” and then press
8
ENTER
.
3
Press
8
l
/
h
to toggle between the audio
and video information.
4
Press
H
MENU
on the remote control again
to exit from “SET MENU”.
■
Audio information
• “–––” appears when this unit cannot display the corresponding
information.
• Some high definition audio bitstream contents may not include
the discrete surround back left and right channel signals but are
encoded at the bitrate of 192 kHz.
• Even if you make settings to output bitstreams directly, some
players convert the Dolby TrueHD or Dolby Digital Plus
bitstreams to the Dolby Digital bitstreams, while converting the
DTS-HD Master Audio or DTS-HD High Resolution Audio
bitstreams to the DTS bitstreams.
■
Video information
HDMI error message
Muting the audio output
Displaying the input source
information (SIGNAL INFO)
[]/[]:
[ENTER]:
[
p
SET MENU
;
AUTO SETUP
;
MANUAL SETUP
;
SYSTEM MEMORY
;
SIGNAL INFO
Up/Down
Enter
.
FORMAT
Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
SAMPLING
The number of samples per second taken from
a continuous signal to make a discrete signal.
CHANNEL
The number of source channels in the input
signal (front/surround/LFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as “3/2/0.1”.
BITRATE
The number of bits passing a given point per
second.
DIALOG
The dialogue normalization level preset to the
current input bitstream signal.
FLAG
Flag data encoded in the bitstream, or PCM
signals that cue this unit to automatically
switch decoders.
Notes
HDMI SIGNAL
Type of the source video signals and
the video signals output at the HDMI
OUT jack of this unit.
HDMI RES.
Resolution of the input signal (analog
or HDMI) and the output signal
(HDMI).
ANALOG RES.
Resolution of the source video signals
and the analog video signals output at
the COMPONENT MONITOR OUT
jacks of this unit.
HDMI ERROR
(HDMI MESSAGE)
Error message for HDMI sources or
connected HDMI devices.
Device over
The number of the connected HDMI
components is over the limit.
HDCP Error
HDCP authentication failed.
Out of Res.
Out of resolution. The connected
monitor is not compatible with the
resolution of the input video signal.
Summary of Contents for RX-V1900BL
Page 133: ......
