Yamaha RX-V100D, Owner'S Manual

Page: 50 / 88

48
DAB (DIGITAL AUDIO BROADCASTING)
4
Press ENTER to select an operation.
The SCAN?[ENTER] verification message appears
in the front panel display if a scan is selected. (The
unit immediately returns to the DAB MENU if
SCAN:NO is selected.)
5
Press ENTER to confirm your selection.
The unit begins scanning the selected band(s) for
DAB ensembles.
• During the scan, “SCANNING“ appears in the
front panel display.
• When scanning has been completed, “FINISH”
appears in the front panel display, followed by the
number of receivable DAB services.
“FINISH [###]” is displayed for three seconds.
Scanning xx%
FINISH [015]
(Example: if 15 services were found.)
After three seconds, the unit returns to the INIT
SCAN menu.
If the INIT SCAN operations are not successful, “Not
Available” appears in the front panel display.
FINISH [000]
Not Available
y
See the DAB section in TROUBLESHOOING for further
details or proper remedies (page 76).
If there are no preset DAB services, Initiate Scan or Not
Available appears in the front panel display.In this time,
press A/B/C/D/E (or PRESET
u
/
d
on the remote
control) to start INIT SCAN automatically.
y
Scanning is performed with the scan mode set in the set menu.
Using TUNE AID, the strength of the DAB signal that the
unit receives is indicated on the front panel display. TUNE
AID is used to adjust the positioning of the DAB antenna
and this unit, in order to discover which setup has the best
reception state.
It is recommended that you use TUNE AID when setting
up this unit in order to maximize DAB reception ability.
1
Access DAB MENU by following steps 1
through 5 as described in “Accessing DAB
MENU” on page 47.
“INIT SCAN” appears in the front panel display.
2
Press
n
.
“TUNE AID” appears in the front panel display.
3
Press ENTER.
The signal strength level of the selected channel
appears in the front panel display. The signal strength
rating is from 00 (none) to 100 (best).
4
Press PRESET/CH
j
/
i
to switch to another
channel label.
The signal strength level of the new channel appears in
the front panel display. For a list of DAB frequencies,
see “DAB Frequency Table” on page 82.
5
Press ENTER exit TUNE AID.
The unit returns to the TUNE AID menu display.
PRESET/CH
ENTER
A/B/C/D/E A/B/C/D/E
SCAN?[ENTER]
PRESET/CH
ENTER
A/B/C/D/E A/B/C/D/E
A)INIT SCAN
TUNE AID
A)INIT SCAN
PRESET/CH
ENTER
A/B/C/D/E A/B/C/D/E
B)TUNE AID
PRESET/CH
ENTER
A/B/C/D/E A/B/C/D/E
5A LEVEL: 80
PRESET/CH
ENTER
A/B/C/D/E A/B/C/D/E
5B LEVEL: 40
PRESET/CH
ENTER
A/B/C/D/E A/B/C/D/E
B)TUNE AID