13
English
7
A/B/C/D/E button
Press this button to select a desired group (A–E) of preset
stations.
8
Preset station number selector buttons
Select a preset station number (1 to 8).
9
Tone controls
These controls are effective only for the sound from the main
speakers.
BASS
Used to increase or decrease the low frequency response.
The 0 position produces flat response.
TREBLE
Used to increase or decrease the high frequency response.
The 0 position produces flat response.
0
BALANCE control
This control is effective only for the sound from the main
speakers.
Adjusts the balance of the output volume to the left and right
speakers to compensate for sound imbalance caused by
speaker location or listening room conditions.
A
FM/AM button
Press this button to switch the reception band to FM or AM.
B
MEMORY (MAN’L/AUTO FM) button
When this button is pressed, the “MEMORY” indicator flashes
for about 5 seconds. While the indicator is flashing, select a
desired preset station number by pressing the corresponding
preset station number selector button to enter the displayed
station into the memory.
When this button is held down for more than 3 seconds, the
automatic preset tuning begins. (For details, refer to page 22.)
C
EDIT button
This button is used to exchange the places of two preset
stations with each other.
D
TUNING DOWN/UP button
Used for tuning. Press the “UP” side to tune in to higher
frequencies, and press the “DOWN” side to tune in to lower
frequencies.
E
TUNING MODE (AUTO/MAN’L MONO) button
Press this button to switch the tuning mode to automatic or
manual. To select the automatic tuning mode, press this
button so that the “AUTO TUNING” indicator lights up on the
display. To select the manual tuning mode, press this button
so that the “AUTO TUNING” indicator goes off.
F
EFFECT button
Switches on/off the digital sound field processor (including the
Dolby Pro Logic Surround decoder).
G
PROGRAM selector button
When the built-in digital sound field processor (including the
Dolby Pro Logic Surround decoder) is on, this button changes
the currently selected DSP program every time the right or left
side of this button is pressed.
H
CENTER MODE button
Selects a center channel output mode (NORM, WIDE or
PHANTOM). (For details, refer to page 16.)
I
CENTER LEVEL control
Adjusts the sound output level of the center speaker.
J
REAR LEVEL control
Adjusts the sound output level of the rear speakers.
