PSR-S710/PSR-S910
60
TEST PROGRAM
* If the test number 67 “Factory Set” is executed, the Internet setup data will be lost.
1 Measurement
Conditions
1-1: Measuring Instruments
· Level meter (with a JIS-C
fi
lter).
· Frequency counter, which can detect thousandth value or more
·
Oscilloscope
* Input impedance of the measuring instrument should be 1 M
Ω
or more.
* Connect a load resistor of 33
Ω
and measure at the [PHONES] jack using stereo plugs unless otherwise speci
fi
ed.
1-2: Jig
Foot controller (FC7), MIDI cable, USB cable, USB storage device (USB
fl
oppy drive, etc.), LAN cable, Router (BUFFALO INC.
BHR-4RV), Display monitor (PSR-S910 only), Microphone (PSR-S910 only)
* For an inspection that requires a pedal unit, inspect with the pedal unit connected.
2
Starting up the test program
Turn on the power switch while pressing and holding the [C#2], [F2], and [G#2] on the lower keyboard (C#2 major code).
[Data entry] encoder
POWER SWITCH button
[DEMO] button
[TAB ] button
[TEMPO +/-] button
[START/STOP] button
2-1: How to carry out tests
1)
“TEST”
will appear on the LCD when the test program starts up.
2) Go to item choosing mode with [TEMPO + ]/[TEMPO - ] button or [Data entry] dial.
(If the [Data entry] dial is turned counterclockwise at the head of items (Test 1), the last item (Test 68) will be selected. If the [Data
entry] dial is turned clockwise at the last item (Test 68), the head of items (Test 1) will be selected.
3) Press the [START/STOP] button to execute a test.
●
If the test result is OK:
When the test result is OK, an asterisk “
*
” will be displayed at the head so that you can see later if it has already been checked.
If the result is OK, return to the selection screen with the [START/STOP] button.
●
If the test result is NG:
If the result is NG, press the [DEMO] button or lowest key on the keyboard to return to the selection display.