14
PSR-S910/S710 Owner’s Manual
Star
ting Up
Starting Up
1
Make sure that the instrument’s [STANDBY/ON] switch is set to
STANDBY (off).
2
Connect one end of the AC cable to the power adaptor.
3
Connect the power adaptor’s DC plug to the instrument’s [DC
IN] terminal on the rear panel.
4
Connect the other end (normal AC plug) to the nearest electrical
outlet.
Before you switch the instrument on or off, first turn down the volume of any
connected audio equipment.
1
Press the [STANDBY/ON] switch.
The main display appears in the display.
Powering Up
Power supply
WARNING
Use the specified adaptor
(page 105) only.
The use of an incompatible
adaptor may cause irreparable
damage to the PSR-S910/S710,
and may even pose a serious
shock hazard! ALWAYS UNPLUG
THE AC ADAPTOR FROM THE AC
POWER OUTLET WHEN THE
PSR-S910/S710 IS NOT IN USE.
CAUTION
Never interrupt the power sup-
ply (e.g. unplug the AC adaptor)
during any PSR-S910/S710
record operation! Doing so can
result in a loss of data.
CAUTION
Even when the switch is in the
“STANDBY” position, electric-
ity is still flowing to the instru-
ment at a minimum level. When
not using the instrument for an
extended period of time, be
sure to unplug the AC power
adaptor from the wall AC outlet.
CAUTION
In order to avoid possible dam-
age to the speakers or other
connected electronic equip-
ment, always switch on the
power of the PSR-S910/S710
before switching on the power
of the amplified speakers or
mixer and amplifier. Likewise,
always switch off the power of
the PSR-S910/S710 after
switching off the power of the
amplified speakers or mixer and
amplifier.
NOTE
Remove the transparent protective
film that was applied to the display
prior to shipment from the factory.
Turning the Power On
1
