Yamaha Phazer Venture Lite PZ50MTA 2011, Supplementary Service Manual

Page: 49 / 78

SPEC
39
PZ50VTA
Injector
Reverse position switch coupler
Drive position switch coupler
Clamp the reverse position
switch lead to the coolant reser-
voir tank with the clamp. Install
the plastic band with its buckle
positioned on top of the coolant
reservoir tank and its end facing
to the right (Make sure not to
clamp the drive position switch
coupler and sub-wire harness.)
Sub-wire harness
Gear motor
Ignition coil
Clamp the wire harness and
fuel tank breather hose to the
frame rear cross member with
the clamp.
Route the wire harness under
the frame rear cross member.
Cylinder identification sensor
Cylinder identification sensor
coupler
Clamp the cylinder identification
sensor lead to the cylinder head
cover boss with the clamp.
To the auxiliary DC outlet
Throttle position sensor lead
coupler
To the speed sensor
Injector sub-wire harness cou-
pler
To the handlebar switch
Speed sensor coupler
To the oil pressure sensor
Oil pressure switch coupler
To the oil pressure switch
To the rectifier/regulator
To the injector sub-wire harness
To the throttle position sensor
coupler
To the body ground (Tighten the
ground lead together with the
rectifier/regulator securing
flange nut.)
Clamp the sub-wire harness at
the white tape with the clamp.
CABLE ROUTING